Technical Support is available at:
8.30-12.30; 13.30-17.30 (CET), Mon-Fri
t: +39.0445.697420 (direct)
e: support[at]videotec.com (ticket)
Follow

NXPTZ SERIES 2: connection diagrams

These connection diagrams depict how the NXPTZ SERIES 2 can be connected to the WASPT and WASNX washer pumps, also optionally through COMB.

Be sure to configure the WASPT for the voltage level used by the NXPTZ SERIES 2 (24, 120, or 230VAC).

Please note that COMB can only power products in 24V.

The Washer control is achieved by the means of an integrated Relay Out, while the Wiper is internally controlled by the unit itself.

NXPTZ SERIES 2 is provided pre-cabled: the diagrams report the wires' colours to be used for the Pump Control.

 

Diapositiva1.jpg

Diapositiva2.jpg

Diapositiva3.jpg

NXPTZ2-COMB-WASPT_ConnDiag.jpgNXPTZ2-COMB-WASNX_ConnDiag.jpg

Was this article helpful?
0 out of 0 found this helpful
, Luca Laghetto wrote this article.
Have more questions? Submit a request

Comments