Technical Support is available at:
8.30-12.30; 13.30-17.30 (CET), Mon-Fri
t: +39.0445.697420 (direct)
e: support[at] (ticket)

MPX SERIES 2: connection diagrams

These connection diagrams depict how the MPX SERIES 2 can be connected to the WASEX's valve, also optionally through MBX or MBA.

The Washer control is achieved by the means of an integrated Relay Out, while the Wiper is internally controlled by the unit itself.

If MBX or MBA is not used, it is necessary to use a suitable insulation transformer, in order to disjoin the valve from the power network.


WARNING: the Insulation Transformer must be installed either inside an explosion-proof box, or in a safe zone out of the classified area.

WARNING: SFP module is not supplied by Videotec







Was this article helpful?
0 out of 0 found this helpful
, Matteo Torresani wrote this article.
Have more questions? Submit a request