Technical Support is available at:
8.30-12.30; 13.30-17.30 (CET), Mon-Fri
t: +39.0445.697420 (direct)
e: support[at] (ticket)

NXPTZ: connection diagrams

These connection diagrams depict how the WASNX and WASPT must be connected to the NXPTZ unit.

Different version for the NXPTZ are available (Analog, SD, HD), but all of them are provided pre-cabled: the diagrams report the wires' colours to be used for the Pump Control.

The Washer control is achieved by the means of an integrated Relay Out, while the Wiper is internally controlled by the unit itself.

Be sure to configure the WASPT for the voltage level used by the NXPTZ (24, 120, or 230VAC).





Was this article helpful?
0 out of 0 found this helpful
, Enrico Bertani wrote this article.
Have more questions? Submit a request